Where does this wire go?

Dr. Demento

New member
Joined
Aug 17, 2020
Messages
7
Reaction score
1
Location
USA
In removing the auger from my used PitBoss 820D, this wire has come free from it's connection. Can anyone tell me where it should go?

It's grounded the the frame under the circuit board and none of the molex connectors are missing any wires. My assumption is that it goes to the circuit board, but I can't see where. Thanks y'all.

IMG_0198.jpg
 
it looks like you have the vertical controller. From this image it does not look like it goes on the board.
a90d3e60-c2c5-46f9-b4b1-55fa7833adfb_1.a0ab3c4a8a522b994b053e360c07a386.jpeg


Looks like a ground wire.

The manual here shows a green wire going to the back of the control board. I am just guessing, if you can't figure it out give them a call. Check page 25 on the manual below

https://www.manualslib.com/manual/751551/Pit-Boss-820.html?page=25#manual
 
Thank you Mike. You are THE guru of all things PitBoss!

Thanks especially for the link for the manual; these folks don't make it easy in finding information about their products. I was having trouble even finding their website at one point.
 
Thank you Mike. You are THE guru of all things PitBoss!

Thanks especially for the link for the manual; these folks don't make it easy in finding information about their products. I was having trouble even finding their website at one point.
No, not really half the time I don't know what I am talking about! :eek: I'm just a regular guy who uses my Pit Boss on the weekends and hope everything turns out OK.
 

Latest Discussions

Back
Top