During smoke mode is that the only time the
P setting is used? I have had two flame outs on smoke mode and if I were to run it at a P3 instead of P4 then the pellets will feed faster so I could avoid another flame out? Or do I just run it at 200-225 to avoid the P setting altogether? It’s has only happened on smoke modes longer than a few hours. Everything else is great at higher temps ect. I have the PB700FB
Thanks
P setting is used? I have had two flame outs on smoke mode and if I were to run it at a P3 instead of P4 then the pellets will feed faster so I could avoid another flame out? Or do I just run it at 200-225 to avoid the P setting altogether? It’s has only happened on smoke modes longer than a few hours. Everything else is great at higher temps ect. I have the PB700FB
Thanks