Championship Barrel

[Jacobturner88]

I have a barrel smoker. The cooking grids will not sit in place and make contact all the way around. I can get them to make contact with three of the notches and have to load very carefully on one supported side. What can I do?

 

[Cowboy1955]

Welcome from Texas to the group!
Is it possible to rivet some angle tabs on it to solve the issue?

 

[Jacobturner88]

Welcome from Texas to the group!
Is it possible to rivet some angle tabs on it to solve the issue?

I’m not sure lol. I don’t know how to rivet or anything. I was about to take some pliers and see if I can bend them or something. I can’t find any info about this problem.

 

[Cowboy1955]

I’m not sure lol. I don’t know how to rivet or anything. I was about to take some pliers and see if I can bend them or something. I can’t find any info about this problem.

Post a picture of what you’re looking at and we can go from there

 

[Jacobturner88]

Post a picture of what you’re looking at and we can go from there

Well I messed around with it some more and figured out the barrel isn’t exactly circular so when I squeeze it together more the grids fit snug properly.

 

[Cowboy1955]

Well I messed around with it some more and figured out the barrel isn’t exactly circular so when I squeeze it together more the grids fit snug properly.

Then I’d just keep pushing until it where they fit fine and you’ll be good

 

[sparkyv]

Go redneck engineering!

 

[Jacobturner88]

Tried to use a ratchet strap to hold it in place but to no avail. Now it’s just more irritating than anything.

 

[Sparky]

Welcome to the club from Texas